Nortel 2350 参考指南
Configuring WSS System Parameters 175
Nortel WLAN—Management Software 2300 Series Reference Guide
Configuring a Port for a Directly Connected AP
An AP access port directly connects the WSS to an AP. The port also can provide power to the AP.
1
Access the Create AP wizard:
a
a
Select the Configuration tool bar option.
b
In the Organizer panel, click the plus sign next to the WSS.
c
Click the plus sign next to System.
d
Select Ports.
e
Select PoE Enabled, if you have not already done so.
f
In the Task List panel, select AP.
2
To change the name, edit the string in the Name field. (The name can contain up to 16 alphanumeric
characters, with no spaces or tabs).
characters, with no spaces or tabs).
3
Click Next.
4
To change the model, select the model from the AP Model pull-down list.
5
To change the radio type, select it from the AP Radio Type drop-down list:
•
11a—802.11a
•
11b—802.11b only
•
11g—802.11b/g
The radio type is configurable on single-radio AP models. For dual-radio models, the radio type is
configurable on the 802.11b/g radio.
configurable on the 802.11b/g radio.
6
Click Next.
7
To enable the radio, select Enabled.
8
In the Channel Number list, select the channel number for the radio.
Note.
A Distributed AP, which is connected to WSSs through intermediate
Layer 2 or Layer 3 networks, does not use an AP access port. To configure for a
Distributed AP, see
Distributed AP, see
Note.
The non-editable number (1 or 2) indicates the radio number on the AP.
Note.
If RF Auto-Tuning for channel configuration is enabled, setting this value
has no effect. The channel number is controlled by RF Auto-Tuning.