Nortel 2350 参考指南
Configuring Wireless Parameters 273
Nortel WLAN—Management Software 2300 Series Reference Guide
Changing Radio Settings
1
Access the radio table:
a
a
Select the Configuration tool bar option.
b
In the Organizer panel, click the plus sign next to the WSS.
c
Click the plus sign next to Wireless.
d
Select Radios.
2
To change basic radio settings, select the new values in the table. To change more advanced features,
select the radio and click Properties.
select the radio and click Properties.
(For information about the radio parameters in the table, see
. For information about
the radio parameters in the Radio Properties wizard, see
3
If you edit settings in the table, click Save. If you configure settings in the Radio Properties wizard,
clicking OK to close the wizard also saves the changes.
clicking OK to close the wizard also saves the changes.
Viewing and Changing RF Detection Settings
This section contains procedures for configuring RF detection on an individual switch. For an overview of RF detection
and for specific information about the configuration options, see
and for specific information about the configuration options, see
.
Viewing RF Detection Settings
1
Select the Configuration tool bar option.
2
In the Organizer panel, click the plus sign next to the WSS.
3
Click the plus sign next to Wireless.
4
Select RF Detection.
The RF detection settings appear in the Content panel.
Note. The tasks available here allow you to configure entries for permit lists, the ignore list,
and the black list. However, you must enter the SSID, Organizationally Unique Identifier
(OUI), or MAC address you are adding to a list. To add a value to a list by selecting it, use
the RF Detection window instead. (See
and the black list. However, you must enter the SSID, Organizationally Unique Identifier
(OUI), or MAC address you are adding to a list. To add a value to a list by selecting it, use
the RF Detection window instead. (See
.)
Note. To convert a rogue into a third-party AP, see
.