Nortel 2350 参考指南
Planning the Nortel WLAN 2300 System 95
Nortel WLAN—Management Software 2300 Series Reference Guide
3
Click the down arrow to display the list of layers in the drawing, and select the layer to which you want to
move the object(s).
move the object(s).
4
Click OK.
Cleaning Up a Drawing
WLAN Management Software can simplify an imported CAD drawing by removing unnecessary objects from each
layer. Drawing cleanup eliminates unneeded objects, lines, and text.
layer. Drawing cleanup eliminates unneeded objects, lines, and text.
Note the following when cleaning up a drawing:
•
Drawing cleanup does not apply to GIF or JPEG drawings.
•
Drawing cleanup does not change objects that are grouped.
•
If two objects that would normally be cleaned (such as two parallel lines close together) exist on different layers,
then neither object is removed.
then neither object is removed.
To clean up a drawing
1
Display the floor plan in the Content panel.
2
In the Task List panel, under RF Planning, click Clean Layout. The Floor Plan Clean Up wizard appears.
Note. You cannot remove a layer from a drawing using the procedure in this section. See