Nortel 2350 用户指南

184 Configuring network domains

NN47250-500 (320657-F Version 02.01)

In a Network Domain, a member WSS consults a seed WSS to determine a user’s VLAN membership in a remote 
Mobility Domain.

Use the following command to set the current WSS as a seed device within a specified Network Domain: 

set network-domain mode seed domain-name net-domain-name

For example, the following command sets the current WSS as a seed with the Network Domain California:

WSS

success: change accepted.

If the seed in a Network Domain is also intended to be a member of the Network Domain, you must enter the following 
command on the seed, with the specified IP address pointing to the seed itself.

set network-domain mode member seed-ip ip-addr [affinity num]

For example, the following command sets the current WSS as a member of a Network Domain where the WSS with IP 
address 192.168.9.254 is a seed:

WSS

success: change accepted.

You can configure multiple seeds in a Network Domain. When multiple Network Domain seeds are configured, a 
member consults the seed with which it has the highest configured affinity. 

If you are configuring multiple seeds in the same Network Domain (for example, a seed on each physical site in the 
Network Domain), you must establish a peer relationship among the seeds. See the following section.