Nortel 2350 用户指南

224 Configuring APs

NN47250-500 (320657-F Version 02.01)

(To configure a service profile, see 

.)

Each radio can support the following types of SSIDs:

•

Encrypted SSID—Clients using this SSID must use encryption. Use the encrypted SSID for secured access to your 
enterprise network.

•

Clear SSID—Clients using this SSID do not use encryption. Use the clear SSID for public access to nonsecure 
portions of your network. 

All supported AP models can support up to 32 SSIDs per radio. Each SSID can be encrypted or clear, and beaconing can 
be enabled or disabled on an individual SSID basis. 

Each radio has 32 MAC addresses and can therefore support up to 32 SSIDs, with one MAC address assigned to each 
SSID as its BSSID. An AP's MAC address block is listed on a label on the back of the access point. If the AP is already 
deployed and running on the network, you can display the MAC address assignments by using the show ap status 
command.

All MAC addresses on an AP are assigned based on the AP’s base MAC address, as described in 

No keys defined

Uses dynamic WEP rather than static 
WEP.

Note: If you configure a WEP key for 
static WEP, WSS Software continues to 
also support dynamic WEP.

Uses WEP key 1 for static WEP 
encryption of multicast traffic if WEP 
encryption is enabled and keys are 
defined.

Uses WEP key 1 for static WEP 
encryption of unicast traffic if WEP 
encryption is enabled and keys are 
defined.

Does not use the WPA IE in transmitted 
frames.

•

The AP has a base MAC address. All the other addresses are 
assigned based on this address. 

•

Ethernet port 1 equals the AP base MAC address.

•

Ethernet port 2 (if the AP model has one) equals the AP base 
MAC address + 1.