Nortel 2350 用户指南

Configuring APs 243

Nortel WLAN—Security Switch 2300 Series Configuration Guide

Finding the fingerprint

An AP’s fingerprint is listed on a label on the back of the AP. (See

If the AP is already installed and operating, use the show ap status command to display the fingerprint. The
following example shows information for Distributed AP 8, including its fingerprint:

WSS# show ap status 8
ap: 8, IP-addr: 10.2.26.40 (vlan 'default'), AP model: 2330,
         manufacturer: Nortel, name: ap08
         fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State:     operational (not encrypted)
CPU info:  IBM:PPC speed=266666664 Hz version=405GPr
                 id=0x29f1886d447f111a ram=33554432
                 s/n=0424000779 hw_rev=A3
Uptime:    1 hours, 8 minutes, 17 seconds

Radio 1 type: 802.11g, state: configure succeed [Enabled]
       operational channel: 1 operational power: 1
      base mac: 00:0b:0e:0a:60:00
      bssid1: 00:0b:0e:0a:60:00, ssid: public
      bssid2: 00:0b:0e:0a:60:02, ssid: nortel
Radio 2 type: 802.11a, state: configure succeed [Enabled]
      operational channel: 48 operational power: 11
      base mac: 00:0b:0e:0a:60:01
      bssid1: 00:0b:0e:0a:60:01, ssid: public
      bssid2: 00:0b:0e:0a:60:03, ssid: nortel

The fingerprint is displayed regardless of whether it has been verified in WSS Software.

Verifying a fingerprint on the switch

To verify an AP’s fingerprint on a WSS, use the following command:

set ap num fingerprint hex

where hex is the 16-digit hexadecimal number of the fingerprint. Use a colon between each digit. Make sure
the fingerprint you enter matches the fingerprint used by the AP.

The following example sets the fingerprint for Distributed AP 8:

WSS# set ap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.

Note.

The show ap config command lists an AP’s fingerprint only if the fingerprint has

been verified in WSS Software. If the fingerprint has not been verified, the fingerprint info in
the command output is blank.