Nortel 2350 用户指南

254 Configuring APs

NN47250-500 (320657-F Version 02.01)

To change the preamble length advertised by 802.11b/g radios, use the following command:

set radio-profile name preamble-length {long | short}

To configure 802.11b/g radios that use the radio profile rp_long to advertise support for long preambles 
instead of short preambles, type the following command:

WSS# set radio-profile rp_long preamble-length long
success: change accepted.

To reset a radio profile parameter to its default value, use the following command:

clear radio-profile name parameter

The parameter can be one of the radio profile parameters listed in 

. 

All radios that use this profile must be disabled before you can delete the profile. If you specify a parameter, 
the setting for the parameter is reset to its default value. The settings of the other parameters are unchanged 
and the radio profile remains in the configuration. If you do not specify a parameter, the entire radio profile is 
deleted from the configuration.

To disable the radios that are using radio profile rp1 and reset the beaconed-ssid parameter to its default 
value, type the following commands:

WSS# clear radio-profile rp1 beaconed-ssid
success: change accepted.

To remove a radio profile, use the following command:

clear radio-profile name 

Make sure you specify the radio profile parameter you want to reset. If you 

do not specify a parameter, WSS Software deletes the entire profile from the 
configuration.

You must disable all radios that are using a radio profile before you can remove 

the profile. (See