Nortel 2350 用户指南
324 Configuring Auto-RF
NN47250-500 (320657-F Version 02.01)
Table 1: Defaults for Auto-RF parameters
Parameter
Default Value
Radio Behavior When Parameter
Set To Default Value
Set To Default Value
Radio profile parameters
channel-config
enable
When the radio is first enabled,
Auto-RF sets the channel based on the
channels in use on neighboring access
points.
Auto-RF sets the channel based on the
channels in use on neighboring access
points.
channel-interval
3600
Every 3600 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the channel needs to be
changed to compensate for RF changes.
examines the RF information gathered
from the network and determines
whether the channel needs to be
changed to compensate for RF changes.
channel-holddown
900
WSS Software maintains the channel
setting on a radio for at least 900
seconds regardless of RF changes.
setting on a radio for at least 900
seconds regardless of RF changes.
channel-lockdown
disabled
WSS Software continues to
dynamically change channels if needed
based on network conditions.
dynamically change channels if needed
based on network conditions.
power-config
disable
WSS Software uses the highest power
level allowed for the country of
operation or the highest supported by
the hardware, whichever is lower.
level allowed for the country of
operation or the highest supported by
the hardware, whichever is lower.
power-interval
300
Every 300 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the power needs to be changed
to compensate for RF changes.
examines the RF information gathered
from the network and determines
whether the power needs to be changed
to compensate for RF changes.
power-lockdown
disabled
WSS Software continues to
dynamically change power settings if
needed based on network conditions.
dynamically change power settings if
needed based on network conditions.
power-ramp-interval
60
When Auto-RF determines that power
should be increased or decreased, WSS
Software changes the power by 1 dBm
every 60 seconds until the power setting
is reached.
should be increased or decreased, WSS
Software changes the power by 1 dBm
every 60 seconds until the power setting
is reached.
Individual radio parameters
max-power
Maximum
allowed for
country of
operation
allowed for
country of
operation
Auto-RF never sets a radio’s power to a
level that is higher than the maximum
allowed for the country of operation
(countrycode).
level that is higher than the maximum
allowed for the country of operation
(countrycode).