Nortel 2350 用户指南

368 Configuring and managing spanning tree protocol

NN47250-500 (320657-F Version 02.01)

STP is disabled by default. You can enable STP globally or on individual VLANs. 

To enable STP, use the following command:

[{all | vlan vlan-id | port port-list vlan-id}]

To enable STP on all VLANs configured on a WSS, type the following command:

WSS# set spantree enable
success: change accepted.

To verify the STP state and display the STP parameter settings, enter the show spantree command. For infor-
mation, see