Nortel 2350 用户指南
697
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Appendix A: Supported RADIUS
attributes
attributes
Nortel WLAN Security Switch 2300 Series (WSS Software) supports the standard and extended RADIUS authentication
and accounting attributes listed in
and accounting attributes listed in
. Also supported are Nortel vendor-specific attributes (VSAs),
listed in
An attribute is sent to RADIUS accounting only if the table listing it shows Yes or Optional in the column marked Sent
in Accounting-Request for the attribute and the attribute is applied to the client’s session configuration. Attribute values
have the following characteristics unless otherwise stated:
in Accounting-Request for the attribute and the attribute is applied to the client’s session configuration. Attribute values
have the following characteristics unless otherwise stated:
•
Strings can contain a maximum of 253 characters.
•
Integers are 4 bytes.
•
IP addresses are 4 bytes.
The RADIUS attributes WSS Software supports are based on these IETF RFCs and drafts:
•
RFC 2865, Remote Authentication Dial-in User Service (RADIUS)
•
RFC 2866, RADIUS Accounting
•
RFC 2868, RADIUS Attributes for Tunnel Protocol Support
•
RFC 2869, RADIUS Extensions
•
draft-congdon-radius-8021x-29.txt (IEEE 802.1X RADIUS Usage Guidelines)
Supported standard and extended attributes
The RADIUS attributes shown in
are sent by WSSs to RADIUS servers during authentication and accounting.