Nortel 2350 用户指南

72 Configuring Web-based AAA for administrative and local access

NN47250-500 (320657-F Version 02.01)

•

Network access mode—Allows network users to connect through the WSS. For information about configuring 
network users, see 

.

WSS Software allows you access to the WSS with the following types of administrative access:

•

Console—Access via only the console port. For more information, see 

•

Telnet—Users who access WSS Software via the Telnet protocol. For information about setting up a WSS for 
Telnet access, see 

•

Secure Shell (SSH)—Users who access WSS Software via the SSH protocol. For information about setting up a 
WSS for SSH access, see 

.

•

WLAN Management Software (WMS)—After you configure the WSS as described in the 

, you can further configure the WSS using the WMS tool suite. 

For more information, see the 

. 

•

Web View—A Web-based application for configuring and managing a single WSS through a Web browser. Web 
View uses a secure connection via Hypertext Transfer Protocol over Secure Sockets Layer (HTTPS).

Administrators must initially configure the WSS with a computer or terminal connected to the WSS console port through 
a serial cable. Telnet access is not initially enabled. 

To configure a previously unconfigured WSS via the console, you must complete the following tasks:

•

Enable an administrator. (See 

•

Configure authentication. (See 

.)

•

Optionally, configure accounting. (see 

•

Save the configuration. (See 

To enable yourself as an administrator, you must log in to the WSS from the console. Until you set the enable password 
and configure authentication, the default username and password are blank. Press Enter when prompted for them.

To enable an administrator:

Log in to the WSS from the serial console, and press Enter when the WSS displays a username prompt:

Username: 

Press Enter when the WSS displays a password prompt.

Password: 

Type enable to go into enabled mode. 

WSS> 

enable