Nortel 2350 用户指南

90 Configuring and managing ports and VLANs

NN47250-500 (320657-F Version 02.01)

applies default settings appropriate for the port type.

lists the default settings applied for each port type. For

example, the AP column lists default settings that WSS Software applies when you change a port type to ap (access
point).

Table 2

lists how many APs you can configure on a WSS, and how many APs a switch can boot. The numbers are for

directly connected and Distributed APs combined.

Table 1: Port Defaults set by port type change

Parameter

Port type

AP Access

Wired Authentication

Network

VLAN
membership

Removed from all
VLANs. You cannot
assign an AP access
port to a VLAN. WSS
Software automatically
assigns AP access ports
to VLANs based on
user traffic.

Removed from all VLANs. You
cannot assign a wired
authentication port to a VLAN.
WSS Software automatically
assigns wired authentication
ports to VLANs based on user
traffic.

None

Note: If you clear a port,
WSS Software resets the port
as a network port but does
not add the port back to any
VLANs. You must explicitly
add the port to the desired
VLAN(s).

Spanning Tree
Protocol (STP)

Not applicable

Based on the STP states of
the VLANs the port is in.

802.1X

Uses authentication
parameters configured
for users.

Uses authentication parameters
configured for users.

No authentication.

Port groups

Not applicable

None

IGMP snooping

Enabled as users are
authenticated and join
VLANs.

Enabled as users are
authenticated and join VLANs.

Enabled as the port is added
to VLANs.

Maximum user
sessions

Not applicable

1 (one)

Not applicable

Table 2: Maximum APs supported per switch

WSS Model

Maximum That Can Be
Configured

Maximum That Can Be
Booted

2382

320

32, 64, 96 or 128,
depending on the license
level

2380

300

40, 80, or 120, depending
on the license level

2360/2361

2350