Nortel 2350 用户指南
184 Configuring network domains
NN47250-500 (320657-F Version 02.01)
Configuring network domain seeds
In a Network Domain, a member WSS consults a seed WSS to determine a user’s VLAN membership in a remote
Mobility Domain.
Mobility Domain.
Use the following command to set the current WSS as a seed device within a specified Network Domain:
set network-domain mode seed domain-name net-domain-name
For example, the following command sets the current WSS as a seed with the Network Domain California:
WSS
# set network-domain mode seed domain-name California
success: change accepted.
If the seed in a Network Domain is also intended to be a member of the Network Domain, you must enter the following
command on the seed, with the specified IP address pointing to the seed itself.
command on the seed, with the specified IP address pointing to the seed itself.
set network-domain mode member seed-ip ip-addr [affinity num]
For example, the following command sets the current WSS as a member of a Network Domain where the WSS with IP
address 192.168.9.254 is a seed:
address 192.168.9.254 is a seed:
WSS
# set network-domain mode member seed-ip 192.168.9.254
success: change accepted.
You can configure multiple seeds in a Network Domain. When multiple Network Domain seeds are configured, a
member consults the seed with which it has the highest configured affinity.
member consults the seed with which it has the highest configured affinity.
If you are configuring multiple seeds in the same Network Domain (for example, a seed on each physical site in the
Network Domain), you must establish a peer relationship among the seeds. See the following section.
Network Domain), you must establish a peer relationship among the seeds. See the following section.