Nortel 4000 用户指南
Managing Remote Access Concentrators Using Annex Manager
Appendix A RAC Parameters
A-2
a_router
defines the Ethernet address that the RAC attempts to use as the AppleTalk router
address. If the router does not respond, the RAC listens for an RTMP packet and
uses the address in the packet as the new router address. You can enter
address. If the router does not respond, the RAC listens for an RTMP packet and
uses the address in the packet as the new router address. You can enter
0
to direct
the RAC to find the router.
acp_key
defines the encryption key used to exchange messages between the RAC and the
security server. You can use this parameter only when the
security server. You can use this parameter only when the
enable_security
parameter is set to
enabled
and a security server is defined. The security server
maintains the encryption key for each RAC in the
acp_keys
file. For security
reasons, Annex Manager displays only
set
or
unset
for the value of this parameter.
The RAC and the security server can communicate only when the
value of this parameter is the same as the value of the RAC in the
security server
value of this parameter is the same as the value of the RAC in the
security server
acp_keys
file.
alarmsyslog
allows the RAC to generate a syslog at the warning level when it detects any
alarm event. To use this feature you must enable syslogging on a RAC using the
alarm event. To use this feature you must enable syslogging on a RAC using the
syslog_facility
,
syslog_host
, and
syslog_mask
parameters.
allow_broadcast
permits an asynchronous port to receive administrative broadcast messages
generated by the
generated by the
Boot
and
Broadcast
commands.
Type
RAC
Values
0 to 253
Default
00-00-00-00-00-00
Lists
RAC Only, AppleTalk
Type
RAC
Values
16 characters
Default
unset
Lists
RAC Only, Security
Type
WAN Module
Values
enabled or disabled
Default
enabled
Lists
DS1 Line, T1_DS1
Type
Async
Values
enabled or disabled
Default
disabled
Lists
Async Port, Basic Async Port