Nortel 4000 用户指南
A-67
Appendix A RAC Parameters
Managing Remote Access Concentrators Using Annex Manager
network_turnaround
controls the number of seconds that a RAC waits for a response from a security
server. An algorithm defines the actual time, which is usually longer than the
number of seconds in this parameter. This parameter works only when
server. An algorithm defines the actual time, which is usually longer than the
number of seconds in this parameter. This parameter works only when
enable_security
is set to
enabled
.
You should not enter a high number here unless you need a long
timeout for contacting a slow host or for waiting for a response to a
security request from a slow host.
timeout for contacting a slow host or for waiting for a response to a
security request from a slow host.
newline_terminal
interprets carriage returns and line feeds for CLI. When you enter
disabled
, a
carriage return or a line feed terminates the input line and a carriage return
followed by a line feed terminates output lines. When you enter
followed by a line feed terminates output lines. When you enter
enabled
, a line
feed terminates both the input and the output lines.
node_id
contains the address a RAC tries to acquire at the start of an AppleTalk session.
If the address you enter here is in use, the RAC must acquire a new node ID.
This new ID is stored in non-volatile RAM. Each ID has two parts, separated by
a dot.
If the address you enter here is in use, the RAC must acquire a new node ID.
This new ID is stored in non-volatile RAM. Each ID has two parts, separated by
a dot.
Type
RAC
Values
1 to 255 seconds
Default
2 seconds
Lists
RAC Only, Security
Type
RAC
Values
enabled or disabled
Default
disabled
Lists
Async Port, Command Line Editing
Type
RAC
Values
0 to 65534.255
Default
0.0
Lists
RAC Only, AppleTalk