Nortel 5399 安装指南
2-19
Chapter 2 Installing the Model 5399 Remote Access Concentrator Module
Model 5399 Remote Access Concentrator Module Hardware Installation Guide
Initializing the Remote Access Concentrator
This section describes how to set up the Remote Access Concentrator,
make the connection to the System 5000 Hub for the first time, and enter
Monitor Mode to configure the module.
make the connection to the System 5000 Hub for the first time, and enter
Monitor Mode to configure the module.
To initialize the Remote Access Concentrator and enter Monitor Mode:
1.
Use a terminal connected to the chassis service port to verify
that the Remote Access Concentrator is operating properly.
that the Remote Access Concentrator is operating properly.
The Slot Selection menu is displayed. The Remote Access
Concentrator should be listed next to the slot number in which it
is installed.
Concentrator should be listed next to the slot number in which it
is installed.
2.
Reset the Remote Access Concentrator by typing r and then
entering the slot number of the chassis that contains the
server.
entering the slot number of the chassis that contains the
server.
The following prompt is displayed:
Are you sure you want to RESET this module? (Y/N):
3.
Answer the question by entering y.
4.
Within 10 seconds, connect to the Remote Access
Concentrator by typing c and then entering the slot number
of the chassis that contains the server.
Concentrator by typing c and then entering the slot number
of the chassis that contains the server.
5.
Wait for the following prompt:
To enter “Monitor Mode” please depress the SPACE key
within 10 seconds.
The prompt counts down from 10 seconds.