Nortel 5399 安装指南
3-15
Chapter 3 ROM Monitor Commands
Model 5399 Remote Access Concentrator Module Hardware Installation Guide
erase
The erase command erases the contents of non-volatile memory
(EEPROM memory). Erasing EEPROM restores all parameters to
factory default values. The syntax is:
(EEPROM memory). Erasing EEPROM restores all parameters to
factory default values. The syntax is:
erase
The erase command prompts for confirmation before erasing the non-
volatile (EEPROM) memory.
volatile (EEPROM) memory.
The
erase
command display looks like this:
The erase command does not erase the Ethernet address.
Since the erase command erases the IP address, you may need
to use the addr command to re-enter the Remote Access
Concentrator’s IP address before reloading any software (if you
are using BOOTP or RARP, you should not set the IP address).
to use the addr command to re-enter the Remote Access
Concentrator’s IP address before reloading any software (if you
are using BOOTP or RARP, you should not set the IP address).
monitor:: erase
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <65504 or 8160 bytes> of non-volatile memory.
Please wait...
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <65504 or 8160 bytes> of non-volatile memory.
Please wait...
16K->|Data 0x0
.........................................
.........................................
.........................................
.........................................
Initialized checksum record installed
.
.
.
.........................................
.........................................
.........................................
Initialized checksum record installed
.
.
.