Nortel 8300 用户指南

下载
页码 134
Managing the VLAN forwarding database
83
About MAC-layer bridge packet filtering
To perform MAC-layer bridging, the switch must know the destination
MAC-layer address of each device on each attached network so it can
forward packets to the appropriate destination. MAC-layer addresses are
stored in the bridging table, and you can filter packet traffic based on the
destination MAC-layer address information.
The MAC filtering supported in the ERS 8300 is the Bridge MIB filtering
(RFC 1493). The number of MAC filters is limited to 100. You create a filter
entry in much the same way as you create a static MAC entry; by entering
a MAC address and the port it resides on. In the MAC filter record, you
also specify the ports for which to discard source or destination packets for
the MAC address on a port.
Configuring VLAN forwarding database filters
To configure a filter:
Step
Action
1
From the Device Manager menu bar, select VLAN > VLANs.
The VLAN dialog box appears with the Basic tab selected. See
2
From the VLAN dialog box, select a VLAN.
3
Click Bridge.
The Bridge, VLAN dialog box appears with the Transparent tab
selected. See
4
Click the Filter tab.
5
Click Insert.
The Bridge, VLAN, Insert Filter dialog box appears. See
Bridge, VLAN, Insert Filter dialog box
Nortel Ethernet Routing Switch 8300
Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device Manager
NN46200-510
03.01
Standard
4.0
27 August 2007
Copyright © 2005-2007, Nortel Networks
.