Nortel 4000 硬件手册
Voice Gateway 4000 Hardware Manual
2-2
303145-A Rev. 00
Rack Mounting
Install the rack mount by bolting it into the 19-inch equipment rack using the four
front panel mounting holes. The mounting holes on the front panel are set on
RTMA standard spacing and fit into any standard equipment rack with 7 inches of
available vertical space.
front panel mounting holes. The mounting holes on the front panel are set on
RTMA standard spacing and fit into any standard equipment rack with 7 inches of
available vertical space.
Equipment slide rails are recommended for installation and provide easier access
to the unit for maintenance and troubleshooting. If you use slide rails, secure the
unit into position by installing four retaining screws in the four holes of the front
panel.
to the unit for maintenance and troubleshooting. If you use slide rails, secure the
unit into position by installing four retaining screws in the four holes of the front
panel.
Caution:
The front panel may not support the weight of a fully loaded system.
Warning:
Failure to install the four retaining screws can cause the chassis to
slide forward if the cabinet is tilted or vibrated resulting in possible
mechanical or electrical damage to the unit or injury to operating personnel.
mechanical or electrical damage to the unit or injury to operating personnel.
Danger:
Electrical power must be connected with a certified power cord for
the country where the equipment is used.