Nortel 450-24t 用户指南

Using the BayStack 450 10/100/1000 Series Switch

1-84

309978-D Rev 01

As shown in Figure 1-49 on page 1-80, switch S2 is set up with two trunk 
configurations (T2 and T3). Both trunks connect directly to switch S1.

As in the previous screen examples, to set up a trunk configuration, choose 
MultiLink Trunk Configuration from the MultiLink Trunk Configuration Menu.

Figure 1-52 shows the MultiLink Trunk Configuration screen for switch S2.

Switch S2 is configured as follows:

•

Trunk (read only) indicates the trunks (1 to 6) that correspond to the switch 
ports specified in the Trunk Members fields.

                           MultiLink Trunk Configuration

Trunk   Trunk Members (Unit/Port)      STP Learning   Trunk Mode    Trunk Status
----- ------------------------------- ------------ --------------- ------------
  1   [  /25 ][  /26 ][  /   ][  /   ] [ Normal   ]      Basic      [ Enabled  ]
  2   [  /1  ][  /3  ][  /   ][  /   ] [ Normal   ]      Basic      [ Enabled  ]
  3   [  /   ][  /   ][  /   ][  /   ] [ Normal   ]      Basic      [ Disabled ]
  4   [  /   ][  /   ][  /   ][  /   ] [ Normal   ]      Basic      [ Disabled ]
  5   [  /   ][  /   ][  /   ][  /   ] [ Normal   ]      Basic      [ Disabled ]
  6   [  /   ][  /   ][  /   ][  /   ] [ Normal   ]      Basic      [ Disabled ]

Trunk     Trunk Name
----- ------------------
  1   [ S2:T2 to S1 ]
  2   [ S2:T3 to S1 ]
  3   [ Trunk #3 ]
  4   [ Trunk #4 ]
  5   [ Trunk #5 ]
  6   [ Trunk #6 ]

Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.  Press Ctrl-C to return to Main Menu.