Nortel 450-24t 用户指南

Using the Console Interface

309978-D Rev 01

3-15

 

The community string used for in-band read-write SNMP operations.

Default

private

Range

Any ASCII string of up to 32 printable characters

1

Number one of four trap IP addresses. Successive trap IP address fields are 
numbered 2, 3, and 4. Each trap address has an associated community 
string (see Community String).

Default

0.0.0.0 (no IP address assigned)

Range

Four-octet dotted-decimal notation, where each octet is 
represented as a decimal value, separated by a decimal 
point

1

The community string associated with one of the four trap IP addresses (see 
Trap #1 IP Address).

Default

Zero-length string

Range

Any ASCII string of up to 32 printable characters

Determines whether a trap will be sent when there is an SNMP 
authentication failure.

Default

Enabled

Range

Enabled, Disabled

Allows you to enable or disable the switch participation in autotopology, 
which allows network topology mapping of other switches in your network.

Default

Enabled

Range

Enabled, Disabled

1

The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks proprietary MIB). 
The status of the row in the MIB table can be set to Valid or Ignore. If the row status is set to Ignore, the fields appear to 
be set when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to 
Valid. When a Trap IP Address is entered from the console, the row status is always set to Valid.