Nortel 8600 参考指南
18
Text conventions
ellipsis points (. . . )
Indicate that you repeat the last element of the
command as needed.
command as needed.
Example: If the command syntax is
ethernet/2/1 [ <parameter> <value>
]...
, you enter
ethernet/2/1
and as many
parameter-value pairs as needed.
vertical line ( | )
Separates choices for command keywords and
arguments. Enter only one of the choices. Do not type
the vertical line when entering the command.
arguments. Enter only one of the choices. Do not type
the vertical line when entering the command.
Example: If the command syntax is
show ip {alerts|routes}
, you enter either
show
ip alerts
or
show ip routes
, but not both.
italic text
Indicates book titles and variables in command syntax
descriptions. Where a variable is two or more words,
the words are connected by an underscore.
descriptions. Where a variable is two or more words,
the words are connected by an underscore.
Example: If the command syntax is
show at <valid_route> , valid_route
is one
variable and you substitute one value for it.
plain Courier
text
Indicates command syntax and system output, for
example, prompts and system messages.
example, prompts and system messages.
Example:
Set Trap Monitor Filters
separator ( > )
Shows menu paths.
Example: Protocols > IP identifies the IP option on the
Protocols menu.
Protocols menu.
Switch numerical ranges
Commands that require you to enter one or more port numbers on the
switch use the parameter <portlist> in the syntax. The following list specifies
the rules for using <portlist>:
switch use the parameter <portlist> in the syntax. The following list specifies
the rules for using <portlist>:
•
A
<portlist>
can be one port on a particular unit (for example, port
3:1).
•
A
<portlist>
can be a range of numbers (for example, port 3:1-3:3).
•
You can add additional unit and port numbers to the list, separated by a
comma (for example, port 3:1,4:8,6:10).
comma (for example, port 3:1,4:8,6:10).
•
You can specify all ports on a particular unit (for example, port 3:*).
•
You can specify all ports on all units (for example, port * indicates all
ports on all units).
ports on all units).
Nortel Metro Ethernet Routing Switch 8600
Documentation Roadmap
NN46220-101
02.01
Standard
4.2
3 August 2007
Copyright © 2007, Nortel Networks
.