Nortel 15000 参考指南
show ip rip timers
308689-B Rev 00
91
show ip rip timers
The
show ip rip timers
command displays the RIP timer values you can use to
control periodic RIP updates (broadcast), when RIP declares a route invalid
(timeout), and the length of time a route is advertised with an infinite metric
(holddown).
(timeout), and the length of time a route is advertised with an infinite metric
(holddown).
The output includes the following information:
show ip routes
The
show ip routes
command displays IP routes. You can use the following
options to display specific information:
RIP Mode
Type of updates RIP sends: rip1 (Version 1 updates), rip2
(Version 2 updates with no aggregation of subnets), or
aggr (Version 2 updates with subnet aggregation).
(Version 2 updates with no aggregation of subnets), or
aggr (Version 2 updates with subnet aggregation).
Trig. Updates
Sends RIP updates when routing changes during
5-second intervals.
5-second intervals.
TTL
IP time-to-live set for RIP updates.
IP Interface
IP interface to which the time interval is applied.
Cct #
Number of the IP interface circuit in the router’s active
MIB.
MIB.
Broadcast Timer
Time interval between RIP updates.
Timeout Timer
Amount of time after which a router is no longer
considered valid.
considered valid.
Hold Down Timer
Amount of time an unused route is held and advertised as
unreachable.
unreachable.
Note:
To display Equal Cost Multipath (ECMP) routes, you must use the
ip routes
command.
<ip_address>
Displays the routes that match the specified IP address.
<
ip_address/prefix
>
Displays the routes that match the specified range.