Nortel 15000 参考指南
show pcap config
308689-B Rev 00
127
PCAP Show Commands
This section describes the PCAP show commands and describes the information
in the tables the router displays.
in the tables the router displays.
show pcap config
The
show pcap config
command displays the current packet capture
configuration. The output of the command includes the following information
:
show pcap state
The
show pcap state
command displays the current packet capture state. The
output of the command includes the following information
:
Circuit
Circuit name assigned to the interface.
Channel
Channel in a DS3 access card or virtual path identifier
(VPI)/virtual channel identifier (VCI) on an ATM module.
(VPI)/virtual channel identifier (VCI) on an ATM module.
Buf Size (KB)
Size of capture buffer in 1024-byte increments.
Pkt Size (Bytes)
Number of bytes saved from a packet.
Dir
Direction of capture: receive, transmit, or both.
Circuit
Circuit name assigned to the interface.
Channel
Channel in a DS3 access card or virtual path identifier
(VPI)/virtual channel identifier (VCI) on an ATM module.
(VPI)/virtual channel identifier (VCI) on an ATM module.
Operational State
Current operational state of the packet capture instance.
Possible values here are:
•
Possible values here are:
•
up -- Registered and enabled.
•
down -- Registered but disabled.
•
init -- Loaded but no interface registered for the
instance.
instance.
•
not present -- Not loaded on the slot connected to the
instance.
instance.
Capture State
State of the packet capture subsystem, either stopped or
started.
started.
Packet Count
Number of packets captured.
Dir
Direction of capture: receive, transmit, or both.