Nortel 15000 参考指南
show t3 vc stats
188
308689-B Rev 00
show t3 vc stats
The
show t3 vc stats
command displays information about the number of IP
packets and bytes transmitted and received over the frame relay DLCI VC (virtual
circuit).
circuit).
This command allows for the following options:
The output includes the following information:
T3 over Mcoc3 vc qos stats
Interface/DLCI
Name of the circuit/number of the frame relay DLCI.
Cct/Queue
Circuit number/name of the queue from the Service
Package.
Package.
RxBelowCIR Packets/Octets
Number of packets/octets received that were below the
committed information rate (CIR).
committed information rate (CIR).
RxAboveCIR Packets/Octets
Number of packets/octets received that exceeded the
CIR, but were within the allocated burst rate (BR).
CIR, but were within the allocated burst rate (BR).
RxAboveBR Packets/Octets
Number of packets/octets received that exceeded the
allocated BR.
allocated BR.
Tx Packets/Octets
Number of packets/octets transmitted.
Dropped Packets
Number of packets that should have been transmitted,
but that were dropped due to lack of buffering resources.
but that were dropped due to lack of buffering resources.
-slot
<arg>
Displays information about the specified slot only.
-name
<arg>
Displays information about the specified T3 circuit.
<arg 1>
Displays information about the specified circuit name.
T3 over Mct3 vc stats
Interface/DLCI
Name of the circuit/number of the frame relay DLCI.
Circuit
The circuit number that this interface runs over.
RxBelowCIR Packets/Octets Number of packets/octets received that were below the
committed information rate (CIR).
RxAboveCIR Packets/Octets Number of packets/octets received that exceeded the
CIR, but were within the allocated burst rate (BR).