Nortel 15000 参考指南
show ethernet flow-control
308689-B Rev 00
49
show ethernet flow-control
Flow-control is a method used to control the transfer of data between two points
on a data network. This avoids data loss when the receiving device buffer is full.
on a data network. This avoids data loss when the receiving device buffer is full.
The
show ethernet flow control
displays information about the flow-control
feature on this router. This command allows for the following option:
The output includes the following information:
show ethernet qos stats
The
show ethernet qos stats command
displays information about the number
of IP packets and bytes transmitted and received over each queue in the assigned
service package. You can specify the following filters with this command:
service package. You can specify the following filters with this command:
-slot
<slot>
Displays information about the specified slot only.
Slot/Conn
Slot location of the Ethernet module within the chassis
and the connector number.
and the connector number.
Flow Cntrl Enable
Indicates whether or not the flow-control feature is
enabled.
enabled.
Pause Zero Enable
Pause Time
Amount of time data transmission was paused.
Received FlowCtrlFrames
Number of frames received without an error.
Transmit Flow Ctrl Frames
Number of frames transmitted without an error.
Received Unsupported
Opcodes
Opcodes
Number of frames received in a misconfigured state.
-slot
<slot>
Displays information about the specified slot only.