Nortel 15000 参考指南
show ethernet summary
308689-B Rev 00
53
show ethernet summary
The
show ethernet summary
command displays the current configuration for all
Ethernet circuits or a specific circuit or slot.
This command allows for the following command filter (flag) and filter argument
:
The output includes the following information:
Trans. Avg Packet
Average packet size (number of bytes divided by number
of frames) transmitted without error.
of frames) transmitted without error.
Multicast Receive
Number of packets received that are not unicast packets.
<slot/conn>
Slot location of the Ethernet module within the chassis and
the connector number.
the connector number.
Slot/Conn
Slot location of the Ethernet module within the chassis
and the connector number.
and the connector number.
Admin State
Configured state of the Ethernet interface: up or down.
HW Address
Line’s physical address. The driver assigns this address.
Operational State
State of the line driver: down, init (initializing), not present
(enabled but not yet started), or up.
(enabled but not yet started), or up.
The not present state occurs for several reasons. For
example, the hardware may not be physically present in
the chassis; the software may be booting and has not yet
initialized the driver software; the slot may be running
diagnostics; or there may be a problem with the
configuration.
example, the hardware may not be physically present in
the chassis; the software may be booting and has not yet
initialized the driver software; the slot may be running
diagnostics; or there may be a problem with the
configuration.