Nortel 1110 用户指南
Installation and configuration
295
8
Wall-mount your phone (optional). Use Method A or Method B to
wall-mount the IP Phone. See Method A—using the mounting
holes on the bottom of the phone stand, or Method B—using the
traditional-style wall-mount box with a CAT5 connector and a 15 cm
(6 inch) CAT5 cord (not provided). See
wall-mount the IP Phone. See Method A—using the mounting
holes on the bottom of the phone stand, or Method B—using the
traditional-style wall-mount box with a CAT5 connector and a 15 cm
(6 inch) CAT5 cord (not provided). See
.
•
Method A: Press the wall-mount lever, and pull away from the
stand. Using the stand cover (see step 3), mark the wall-mount
holes by pressing the bottom of the stand cover firmly against
the wall in the location where you wish to install the phone. Four
small pins on the bottom of the stand cover make the marks on
the wall. Use the marks as a guideline to install the wall-mount
screws (not provided).
stand. Using the stand cover (see step 3), mark the wall-mount
holes by pressing the bottom of the stand cover firmly against
the wall in the location where you wish to install the phone. Four
small pins on the bottom of the stand cover make the marks on
the wall. Use the marks as a guideline to install the wall-mount
screws (not provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the
wall, and then install the phone stand mounting holes over the
screw heads. You may need to remove the phone from the wall
to adjust the lower screws. When the lower screws are snug,
install the phone on the mounting screws, and then tighten the
top screws.
wall, and then install the phone stand mounting holes over the
screw heads. You may need to remove the phone from the wall
to adjust the lower screws. When the lower screws are snug,
install the phone on the mounting screws, and then tighten the
top screws.
•
Method B: Attach the 15 cm (6 inch) CAT5 cable (not provided),
position the stand over the mounting rivets, and slide the phone
down the wall so that the rivets fit into the slots on the stand.
position the stand over the mounting rivets, and slide the phone
down the wall so that the rivets fit into the slots on the stand.
9
Replace the stand cover. Ensure that all cables are neatly routed
and press the stand cover into place until you hear a click.
and press the stand cover into place until you hear a click.
10
If you wall-mount the phone, put it in the wall-mount position by
holding the tilt lever and press the phone towards the base until the
phone is parallel with the base. Release the tilt lever and continue
to push the phone towards the base until you hear an audible click.
Ensure the phone is securely locked in to position.
holding the tilt lever and press the phone towards the base until the
phone is parallel with the base. Release the tilt lever and continue
to push the phone towards the base until you hear an audible click.
Ensure the phone is securely locked in to position.
11
Connect additional cables. Connect the Ethernet cable to the LAN
Ethernet connection. If you are using an AC power adapter, plug the
adapter into an AC outlet.
Ethernet connection. If you are using an AC power adapter, plug the
adapter into an AC outlet.
—End—
Startup sequence
When an IP Phone 1110 connects to the network, it must perform a startup
sequence. The elements of the startup sequence include
sequence. The elements of the startup sequence include
•
obtaining VLAN ID (if supported by the network infrastructure)
•
obtaining the IP parameters
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368
02.01
Standard
Release 5.0
7 December 2007
Copyright © 2003–2007, Nortel Networks
.