Optoma hd8200 用户手册
English
Appendices
Image is too small or too large
Adjust the zoom lever on the top of the projector.
Move the projector closer to or further from the screen.
Press [Menu] on the projector panel, go to “Display-->Format”. Try
the different settings.
Image has slanted sides:
If possible, reposition the projector so that it is centered on the
screen and below the bottom of the screen.
Use “Display-->V Keystone” from the OSD to make an adjustment.
Image is reversed
Select “System-->Projection” from the OSD and adjust the projec-
tion direction.
Other Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and
wait at least 20 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
page 42.