MTX tx1000 用户指南

BEFORE STARTING
MTX recommends that you have your new speakers installed by an authorized MTX 
retailer, preferably MECP certifi ed. If you do decide to do it yourself, make sure you 
have read the instructions carefully, and that you have the following tools: 
  • Electric drill
  • Phillips bit or screwdriver
  • 1/8” bit
  • Door panel puller 
  • Wire cutters/crimpers 
  • Metal cutting tool
  • Safety glasses
  • X-acto knife

Please be aware that today’s cars have door panels that are not designed to come 
apart easily; they are designed by the factory to sit tight against the door and not 
rattle. It is important to note that if the proper procedures are not followed, the door 
panels can easily become
damaged which can make them fi t improperly when you’re trying to reinstall them.

There are often hidden screws that, if overlooked, can cause the panel to crack or 
break when force is applied to remove door panel. Even new car owners need to be 
aware of this potential issue. Buying a new door panel is an expensive process so 
please take note of the potential for damage.

With the door panel off, it is a perfect time to add sound dampener. The main goal 
of sound dampeners is to add mass to the metal in the door, causing less rattle and 
“ring” which will help to improve the overall sound of your new speakers. It also 
helps prevent against outside noise by adding insulation. Sound dampening material 
can be bought from numerous manufactures in many different forms, and kits, for 
many different applications. Please make sure you purchase the correct type for your 
specifi c project.

Note: Before cutting anything, please use common sense and make sure that no 
wires or glass will interfere with cutting tools. ALWAYS WEAR PROPER SAFETY 
GLASSES. Be sure all wires are clear of moving parts such as window crank
mechanisms and trunk hinges. Use rubber grommets when running wires through 
sharp edged metal holes, which may wear through the wire’s insulation. 

Do not mount speakers in the following locations:
• Where the doors window glass comes in contact with the speaker/s
• Where the window crank handles or gear assemblies come in contact with the
   speaker when rotated
• Where the speakers come in contact with the trunk springs, shock towers, or
   trunk lid
• Where the speakers come in contact with the gas tanks, or fuel lines
• Where the speakers come in contact with the rear window glass, car wall, etc...

INTRODUCTION
Thank you for choosing MTX to help reach your ultimate goal with your vehicle. 
Adding MTX separates and a matching MTX amplifi er with StreetWires connections 
will put you in a better position to hear, feel and experience all of the music the artist 
intended you to hear. 

4”
Separate

5-1/4”
Separate

6-1/2”
Separate

25mm 
Tweeter

Polypropylene 
with Aluminum 
Deposition

Polypropylene 
with Aluminum 
Deposition

Polypropylene 
with Aluminum 
Deposition

N/A

25mm
Soft Dome

25mm
Soft Dome

25mm
Soft Dome

25mm
Soft Dome

4 Ohm

4 Ohm

4 Ohm

4 Ohm

74Hz-20kHz

51Hz-20kHz

44Hz-20kHz

2.5kHz-20kHz

75

90

90

50

150

180

180

100

90dB

90dB

90dB

90dB

1”

1”

1”

25mm

1.5 mm

2.75 mm

2.75 mm

N/A

1-7/8”

2-3/16”

2-3/16”

N/A

3-3/4”

4-11/16”

5”

N/A

1”

1”

1”

1”

1-7/8”

1-7/8”

1-7/8”

1-7/8”

Flush, Surface, 
Angle

Flush, Surface, 
Angle

Flush, Surface, 
Angle

Flush,
Surface, 
Angle

2-Way. 
18dB/6dB

2-Way. 
18dB/6dB

2-Way. 
18dB/6dB

1-Way.
18dB

0, -3,

0, -3,

0, -3,

N/A

TX Owners manual.indd   2-3

3/9/05   4:45:35 PM