Lowrance 5200c 操作指南

 

79 

A message and tone appear periodically, warning you that the simula-

tor is on. To turn the simulator off, repeat the above steps or turn the 

unit off. 
While in simulator mode, you can press 

 to clear the steering and 

speed boxes from the screen while continuing the simulation. This will 

allow you to use the map cursor during a simulation.  
To turn steering and speed boxes back on again, return to the GPS 

Simulator menu, select the 

 command, press 

, then 

Press 

|

|

 to return to the previous page. 

Simulating Trail or Route Navigation 
In Simulator mode, your unit can automatically follow a trail or route 

without manual steering if you use these steps: 
1. From the Map Page, go to the simulator menu. Pick a 

 at or near the beginning of your trail/route. Enter an approximate 

 (shown in compass degrees) that will point you toward the start 

of the trail/route. 
2. Set 

 to zero. Select 

 command and press 

, 

which turns on the simulator and returns you to the Map Page. 
3. Begin navigating along the trail/route. If you are close enough to the 

first waypoint, the arrival alarm will usually go off as soon as naviga-

tion begins. Press 

 to clear the alarm. When navigation starts, 

press 

↑ to increase speed to the desired setting. 

4. Press 

 to turn off the steering and speed boxes. The unit will now 

automatically "steer" along the trail or route. When you arrive at your 

"destination," cancel navigation as you normally do. 

You can pick any spot on the map to begin your simulation session 

by using the Initialize GPS command. This makes your unit think 

it's located at the position you select. 

This command is used when you are practicing in simulator mode. (See 
the entry in this section for GPS Simulator.) In simulator mode, this 

command makes the unit operate as if it is sitting someplace other 

than its actual location. So, you and your unit could be located in Kan-

sas City, but easily practice navigating in the ocean off Islamorada, 

Florida. 
1. Press 

|

|

↓ to 

|

|

.