Lowrance 7200c 操作指南

135 

5. Select the desired fluid type and press 

. The following message 

will appear: Are you sure you wish to change this device's configuration? 
6. Highlight 

 and press 

. Press 

 repeatedly to get back to the 

main display. 

1. Press 

, use 

↑ ↓ to select 

 and press 

. The 

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.  
2. Highlight 

 and press 

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page.  
3. Select the desired fluid level and press 

. The Fluid Level Device 

Configuration menu will appear. 
4. Highlight 

 and press 

. Use 

↑ ↓ ,← → to input the size of 

the tank and press Enter. The following message will appear: Are you 
sure you wish to change this device's configuration? 
5. Select 

 and press 

. Press 

 repeatedly to get back to the 

main display. 
Advanced Options menu 
The Fuel Flow sensor Advanced Options menu contains two categories: 

Instance and Restore Defaults.  

 

The Instance command is intended for use only by experienced NMEA 

2000 network technicians. Instance allows network technicians to re-

solve certain electronic probe conflicts. This is most likely to occur if the 

network includes LMF-200 or LMF-400 digital gauges, which support 

the display of fewer electronic probes than your GPS or sonar/GPS unit. 

If you want to use your unit in a network including one of these digital 

gauges, you may need to consult customer service. 
You should never need this command if you are connecting your unit to a 

network with similar display units and/or a series of electronic probes.  

The Restore Defaults command allows you to reset an individual EP-15 

Fluid Level Sensor's settings to factory defaults. If, for example, you 

execute the Restore Defaults command from your Gray Water Fluid 

Level Advanced Options menu, only the settings for the Gray Water 

Fluid Level will be reset to factory defaults. Other fluid levels on the 

network will not be affected.