Lowrance lcx-112c 操作指南
197
5. Highlight the desired location and press
ENT
. The following message
will appear: Are you sure you wish to change this device's configuration?
6. Select
6. Select
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to
2000 network technicians. Instance allows network technicians to
resolve certain electronic probe conflicts. This is most likely to occur if
the network includes LMF-200 or LMF-400 digital gauges, which
the network includes LMF-200 or LMF-400 digital gauges, which
support the display of fewer electronic probes than your GPS or
sonar/GPS unit.
If you want to use your unit in a network including one of these digital
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to a
You should never need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults. If, for example, you execute
Fuel Flow Sensor's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Port Fuel Flow Advanced
Options menu, only the settings for the Port Fuel Flow will be reset to
factory defaults. Other fuel flows on the network will not be affected.
factory defaults. Other fuel flows on the network will not be affected.
To restore default settings:
1. Press
MENU| MENU
, use
↑ ↓ to select
NMEA
2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Use
3. Use
↑ ↓ to select the desired fuel flow and press
ENT
. The Device
Configuration menu will appear.
4. Highlight
4. Highlight
A
DVANCED
O
PTIONS
and press
ENT
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.