Lowrance lcx-112c 操作指南
26
Speed sensor mounting configuration:
side view (left) and rear view (right.)
If the base of the transom has a radius, fill the gap between the transom and
the sensor with the sealant. This will help ensure a smooth water flow.
Route the sensor's cable through or over the transom to the sonar unit.
If you need to drill a hole in the transom to pass the connector through,
Route the sensor's cable through or over the transom to the sonar unit.
If you need to drill a hole in the transom to pass the connector through,
the required hole size is 7/8".
CAUTION:
CAUTION:
If you drill a hole in the transom for the cable, make sure it is
located above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline
sealant used for the screws.
sealant used for the screws.
The sensor is now ready for use. Connect the sensor to the sonar socket
on the back of your unit and connect the transducer to the speed
sensor's socket. If you have any questions concerning the installation of
sensor's socket. If you have any questions concerning the installation of
the sensor, please contact your local boat dealer.
GPS Antenna/Receiver Module
The LCX-27C, LCX-28C HD, LCX-37C, LCX-38 C HD, LCX-112C and LCX-
113C HD packages include the LGC-3000 GPS module. This device contains
113C HD packages include the LGC-3000 GPS module. This device contains
the unit's external antenna and receiver for GPS and WAAS signals. The
antenna/receiver module comes with a 15-foot extension cable. This module
can be mounted on a flat surface or pole, or an optional magnet is available
can be mounted on a flat surface or pole, or an optional magnet is available
for temporary mounting on any ferrous surface.
LGC-3000 Module, bottom view (left) and top view (right).
Transom
Bottom of hull
Bottom of hull