Lowrance lms-320 用户手册

149

To get to the GPS Simulator:
1. Press 

|

|

↓ to 

|

.

2. Press 

↓ to 

|

. The GPS Simulator Menu appears.

   

GPS Setup Menu, left; GPS Simulator menu, right.

Make the desired settings, then turn the simulator on by highlighting
the 

 box and pressing 

 key. Press 

|

|

to erase this menu. A message and tone appears periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.

While in simulator mode, you can press 

 to clear the steering and

speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the 

 command, press 

, then Press

|

|

 to return to the previous page.

Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:

1. From the Map Page, go to the simulator menu. Pick a 

 at or near the beginning of your trail/route. Enter an approximate

 (shown in compass degrees) that will point you toward the start

of the trail/route.

2. Set 

 to zero. Select 

 

command and press

  ENT,

which turns on the simulator and returns you to the Map Page.

3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press 

 to clear the alarm.) When navigation starts,

press 

↑ to increase speed to the desired setting.