Lowrance lms-350a 操作指南
4
50 kHz
TRANSDUCER
192 kHz
TRANSDUCER
TRANSDUCER
ADAPTER
CABLE
(MY-2)
The white wire is for a NMEA interface. The LMS-350A sends data to
another electronic navigation devices through the white wire. It receives
data from a differential (DGPS) beacon receiver through the green wire.
If the white and green wires are not used, tape their ends so that they
cannot short.
another electronic navigation devices through the white wire. It receives
data from a differential (DGPS) beacon receiver through the green wire.
If the white and green wires are not used, tape their ends so that they
cannot short.
To connect a device to the LMS-350's NMEA output (white wire), attach
a shielded, twisted pair cable from the device's NMEA intput to the
white wire on the LMS-350's power cable. Solder the ground conductor
of the twisted pair and the shield to the black wire on the power cable.
Do not connect the shield to the other device. Use the green and black
wires in the same manner to attach a DGPS recevier's output to the
LMS-350's input (green wire). See the other instrument's manual and
the NMEA section in this manual for more information.
a shielded, twisted pair cable from the device's NMEA intput to the
white wire on the LMS-350's power cable. Solder the ground conductor
of the twisted pair and the shield to the black wire on the power cable.
Do not connect the shield to the other device. Use the green and black
wires in the same manner to attach a DGPS recevier's output to the
LMS-350's input (green wire). See the other instrument's manual and
the NMEA section in this manual for more information.
TRANSDUCER CONNECTIONS
The LMS-350A has dual frequency capability. It can operate at 50 or
192 kHz, separately, or at the same time. The connection diagram
below shows the proper method to attach the transducers to the LMS-
350A. See the transducer owner’s manual for transducer installation
instructions. If dual frequency (simultaneous) operation is desired, a 50
kHz transducer and the MY-2 transducer adapter cable must be pur-
chased separtately.
The LMS-350A has dual frequency capability. It can operate at 50 or
192 kHz, separately, or at the same time. The connection diagram
below shows the proper method to attach the transducers to the LMS-
350A. See the transducer owner’s manual for transducer installation
instructions. If dual frequency (simultaneous) operation is desired, a 50
kHz transducer and the MY-2 transducer adapter cable must be pur-
chased separtately.
See page 18 for more information on dual frequency operation.
"T" CONNECTOR ON
LMS-350A
SINGLE FREQUENCY
192 kHz or 50 kHz
TRANSDUCER
"T" CONNECTOR ON
LMS-350A
DUAL
FREQUENCY