Lowrance lms-522c igps 操作指南

18 

Place the ratchets into the bracket with the letter "A" aligned with the 

alignment mark molded into the bracket. Place the ratchets onto the 

transducer with the letter "A" aligned with the 12 o'clock position on 

the transducer stem. These positions set the transducer's coarse angle 
adjustment for a 14

° transom. Most outboard and stern-drive transoms 

have a 14

° angle. 

 

 

 

A. One-piece bracket: Slide the transducer between the two ratch-

ets. Temporarily slide the bolt though the transducer assembly and 

hold it against the transom. Looking at the transducer from the side, 

check to see if it will adjust so that its face is parallel to the ground. 

If it does, then the "A" position is correct for your hull.