Extreme 3802 硬件手册
Mini-GBIC Type and Hardware/Software Support
Extreme Networks Consolidated Hardware Guide
31
Figure 1: Mini-GBIC modules
Mini-GBICs are Class 1 laser devices. Use only Extreme-approved devices.
NOTE
Remove the LC fiber-optic connector from the mini-GBIC prior to removing the mini-GBIC from the
switch.
switch.
CAUTION
Mini-GBICs can emit invisible laser radiation. Avoid direct eye exposure to beam.
If you see an amber blinking mini-GBIC port status LED after you install a mini-GBIC into the
Summit24e3 or Summit48si switch, this means the mini-GBIC is not certified by Extreme Networks. To
correct this problem, install an Extreme Networks-certified mini-GBIC, available from Extreme
Networks, into the port in the switch.
Summit24e3 or Summit48si switch, this means the mini-GBIC is not certified by Extreme Networks. To
correct this problem, install an Extreme Networks-certified mini-GBIC, available from Extreme
Networks, into the port in the switch.
To remove the mini-GBIC connector labeled “Module A,” gently depress and hold the black plastic tab
at the bottom of the connector and pull the mini-GBIC out of the port on the switch.
at the bottom of the connector and pull the mini-GBIC out of the port on the switch.
To remove the mini-GBIC connector labeled “Module B,” gently lift down on the front handle and pull
the mini-GBIC out of the port on the switch.
the mini-GBIC out of the port on the switch.
To insert a mini-GBIC connector:
1
Holding the mini-GBIC by its sides, insert the mini-GBIC into the port on the switch.
2
Slide the mini-GBIC into the port, until you hear it click. If the mini-GBIC has a handle, push up on
the handle to secure the SX mini-GBIC.
the handle to secure the SX mini-GBIC.
XM_024
Module A
Module B