Intermec 2430 用户指南

nugget

39 AGaramond

 Run 

EM9560.BIN 

 

*/O/OC/ZEM9560/NBIN*

 

 *//C:EM9560.BIN* 

The terminal boots, resets all firmware, and runs the application. The 
initial screen for the application appears. You see one of these screens: 

 

1998/01/00

12:00:00

 

If you are using a large font size or small column width, only the hours 
and minutes will be displayed on the APPTSK.BIN initial screen. For 
help, see “Display Spacing” on page 180. 

Scan this bar code label to toggle the clock display on or off. 

  Toggle Clock Display 

 

*CLOCKDISPLAY*

 

 *CLOCKDISPLAY* 

Use the application to scan bar code labels, enter data through the 
keyboard, and transmit data. 

This section lists some examples of how you can use the applications with 
your Trakker Antares terminals. 

Use the application to troubleshoot and test communications before 
loading and running your data collection application. Connect the 
terminal to your network. Type data (“Hello World”) on the Trakker 
Antares terminal keyboard or scan a bar code label. The data is sent out to 
all serial and network ports and should be received by the host if your 
terminal is installed and configured correctly. Send data from the host and 
verify that the data appears on the terminal screen.  

Connect a serial input device, such as a 1550 scanner, to a serial port on 
the Trakker Antares terminal. Data from the input device is displayed on 
the terminal screen and transmitted out the network (Ethernet or RF) 
port.