Intermec 2480 快速安装指南
nugget
d 39
Trakker Antares 248X Stationary Terminal Quick Start Guide
19
TCP/IP
Direct Connect
UDP Plus
or WTP
Ethernet
Host
2485/6
2485/6
2485/6
2485/6
Access
point
point
Access
point
point
G4000
To configure the 2485 or 2486 to use RF communications
1
Configure the Intermec Gateway or DCS 30X (UDP Plus or WTP), or
host (TCP/IP). For help, see the documentation that shipped with the
Intermec Gateway or the user’s manual for the DCS 30X.
host (TCP/IP). For help, see the documentation that shipped with the
Intermec Gateway or the user’s manual for the DCS 30X.
2
Configure the access point. For help, see the access point user’s manual.
3
Press the
œ
key on the keypad.
The Boot Menu appears.
Note: If the backup battery charge
is low, you may need to press • to
exit a battery information screen.
is low, you may need to press • to
exit a battery information screen.
4
Press
1
to boot the terminal and
initialize the firmware. The Trakker
Antares screen appears.
Antares screen appears.
Next, either a sample application
BOOT MENU
F1 - Boot System
F2 - Run Loader
F3 - Power Down
POWER DOWN IN 60 SEC
2455G.019
screen or a TE 2000 terminal emulation application welcome screen
appears. If there is no application loaded on the 2485/6, a cursor
appears in the upper left corner of the screen.
appears. If there is no application loaded on the 2485/6, a cursor
appears in the upper left corner of the screen.
5
The “Using the Menu System to Configure the Terminal” section on
page 20 explains how to use the TRAKKER Antares 2400 Menu
System. Use the menu system to set:
page 20 explains how to use the TRAKKER Antares 2400 Menu
System. Use the menu system to set:
• Time and Date.