Intermec 9710 参考指南
Decision Data 3791
C d 39
18
Decision Data 3791
This section covers the Decision Data 3791 workstation. The individual Wedge
Interface Guide corresponding to this section is part number 054765.
Interface Guide corresponding to this section is part number 054765.
Cables
Connecting the reader to the Decision Data 3791 workstation requires two cables: a
keyboard cable and a terminal cable. The interface kit contains both the keyboard and
terminal cables. If you need to order a replacement cable, use the part numbers listed
below:
keyboard cable and a terminal cable. The interface kit contains both the keyboard and
terminal cables. If you need to order a replacement cable, use the part numbers listed
below:
• Wedge interface kit (P/N 054764)
• Keyboard cable (P/N 054763)
• Terminal cable (P/N 054762)
• Keyboard cable (P/N 054763)
• Terminal cable (P/N 054762)
Power Supply
The reader does not require an external power supply to work with the workstation. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Workstation Configuration
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
83-key Keyboard
*$+TA227*
*$+TA227*
122-key Keyboard
*$+TA314*
*$+TA314*