Intermec 9710 参考指南
IBM 3178
C d 39
48
IBM 3178
This section covers the IBM 3178 workstation. The individual Wedge Interface Guide
corresponding to this section is part number 054808.
corresponding to this section is part number 054808.
Cables
Connecting the reader to the IBM 3178 workstation requires one cable. The interface kit
contains the keyboard/terminal cable. If you need to order a replacement cable, use the
part numbers listed below:
contains the keyboard/terminal cable. If you need to order a replacement cable, use the
part numbers listed below:
• Wedge interface kit (P/N 054809)
• Keyboard/Terminal cable (P/N 054807)
• Keyboard/Terminal cable (P/N 054807)
Power Supply
The reader does not require an external power supply to work with the workstation. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
C1 Keyboard
*$+TA308*
*$+TA308*
C2 Keyboard
*$+TA309*
*$+TA309*
C3 Keyboard
*$+TA310*
*$+TA310*
C4 Keyboard
*$+TA311*
*$+TA311*