Intermec 1470 用户指南

This selection allows you to program the imager to read fixed VeriCode bar code sizes.
If your application requires that the imager read one fixed size, scan one of the Size
menu bar codes and the size (from 10 to 48, even numbers only). The size you set will
be the only one turned on.  If you need more sizes turned on (up to 3), scan another Size
menu bar code and the required size(s). The default is 0 or Off (all sizes turned on).

Size A

Size B

Size C

Size D

Size E

A one- to two-digit number and Save are required after reading this programming bar
code. Refer to the “General Programming Chart” in Appendix B.

This section includes codes and information for the Test Menu and 2D Scan
Diagnostics.

When you set Test Menu On then scan a programming code in this manual, the imager
displays the content of a programming code. The programming function will still occur,
but in addition, the content of that programming code is output to the terminal. You may
wish to use this feature in conjunction with QuickView. For information on QuickView,
see Chapter 5, “Using QuickView.”

This feature should not be used during normal imager operation.