LiteOn lvc-9015g 用户指南

Timer Record

8. [

] [] to select “Date” and press [ENTER] .

Press [

] [] [] [] to make your selection and [ENTER] for

confirmation. To enter the number, use the numbered buttons (0,
1~9).

Once:

DATE: MM/DD

Weekly: DATE: SUN/MON/TUE/WED/THU/FRI/SAT
Daily:

DATE: - - - - -

(when the “daily” mode is selected, skip to step 8)

If you make a mistake, press

[

]

to re-enter the

correct number.

Note:

When scheduling timer recording on a disc, the unit automatically
sets the recording quality depending on the length of the recording
item. If you wish to set other modes of recording quality, proceed
with step 11.

9.Press [

] [] to select “Quality” and then

press [ENTER] to set the mode of recording
quality.

DVD disc recording mode:

HQ <-> SP <-> EP <->
LP <->SLP

Tape recording mode: SP <-> SLP

10 .When finished, press [

][] to select the “

” icon and then press [ENTER] to exit the
“Timer-Record” menu.

If you wish to delete a timer record item, press [

] [] []

[

] to move to the “ ” icon and press [ENTER]. The item

is deleted.

11.Press [POWER] to turn off the unit and acti-
vate the timer record function.

Notes:

1.When the timer record function is active, the “Timer” LED on the
display panel will light up.

2. Press [

STOP ] and the recording will be stopped. However,

the recorder may take a few seconds to finish recording on the disc
or tape.
3. Press [DISPLAY] and the timer record information is displayed.
4.Check the status column to see the recording failure analysis:
OK -

The event is programmed and ready to record.

Error - There is a problem with the event settings. Change the
settings until the Status is “OK.”
Done - The event recorded successfully.
Fail -

The event failed to record. Move the cursor to the

Status column to view the cause of the error (“No Disc,”
“ Media Defect,” “Disc Full,” and etc. ).