LiteOn dd-500g 用户指南

Option 3   Using HDMI Cable (Select Models Only)
If your TV supports HDMI, use a HDMI cable to connect 

the HDMI OUT jack on this DVD recorder to the HDMI 

IN jack on the TV. 



 

 After all connection steps are done, the DVD recorder 

and TV start to create HDCP (High-bandwidth Digital 

Content Protection) connection which prevents the 

signal transmitted via HDMI cable from being copied. 

If this HDCP connection fails to build, a warning 

window will pop up. Press  and ENTER to try 

again. Or disconnect the HDMI cable and use another 

kind of video cable for connection. If you select 

‘EXIT’ without disconnecting the cable or do not 

make a choice in 10 seconds, the warning message 

will disappear. However, next time when you watch 

HDCP-encrypted content, the window pops up again.

 ..........................................................................................



   If you choose option 3 in step 2, set the ‘HDMI 

Output’ to ‘Video+Audio’ in the Setup menu and do 

not connect the DVD recorder to an audio amplifier or 

receiver, then you can skip this step. 

  Setting HDMI(p.18)

Option 1   Using Composite Cable
Use the audio (red and white) ends of a composite cable to 

connect the AUDIO OUT jack on the DVD recorder to the 

AUDIO IN jack on the television.

Option 2   Connecting to a Stereo Audio Amplifier or 

Receiver

Use the audio (red and white) ends of a composite cable to 

connect the AUDIO OUT jack on the DVD recorder to the 

AUDIO IN jack on a stereo amplifier or a receiver.

 ..........................................................................................

Option 1  Using Composite Cable
Use the video (yellow) end of a composite cable to 

connect the VIDEO OUT jack on the DVD recorder to the 

VIDEO IN jack on the television.

Option 2   Using Component Cable
Use a component video (with green, blue and red ends) 

cable to connect the COMPONENT OUT jack on the 

DVD recorder to the COMPONENT IN jack on the 

television.



 

 If your television supports ‘Progressive Scan’ mode, 

you may adjust the ‘Video Output’ setting accord-

ingly in setup menu for better results. Go through 

SetupSystemVideo Output, and select ‘Progres-

sive’.