LiteOn dd-500g 用户指南

Timer Recor

ding

Path 1:

1. Press VCR Plus+ button to display the VCR Plus+

menu.

Path 2:

1. Press TIMER to display the Timer Record menu.
2. Press ENTER to start a new setting, or press 

to select a previous setting which you would like to

modify, then press ENTER.

3. Press  to go to the ‘VCR Plus+’ button, then

press ENTER to display the VCR Plus+ setup menu.

..........................................................................................

1. Press number buttons (0-9) or to enter the

PlusCode number, then press ENTER.

Timer_03_01

Details of the preset program will be displayed.

2. The ‘Preset Channel’ dialogue box will then appear,

if the DVD recorder fails to ﬁnd information of a

corresponding channel. Press  to enter the number

of channel which corresponds to the guide channel

number designated by the VCR Plus+ system, then

press ENTER.

Timer_03_01

To make use of the VCR Plus+ system for timer

recording, you need to match the GCNs (guide

channel numbers) used by the VCR Plus+ system

with the channel numbers shown on your TV, so that

the relevant information can be correctly assigned to

the programs you would like to record.

3. Set ‘Mode’ (recording mode) and ‘Repeat’ (recording

frequency) for the timer program.
Press  to select one of the setting, then press

ENTER to go to the sub-menu. Press to select,

then press ENTER to conﬁrm your selection.

4. Follow step 6-8 in ‘Setting Timer Program [Date/Time

Mode]’ to complete the setting.



If you want to return to the Date/Time mode, press



to select ‘Date/Time Setting’, then press

ENTER. However, please note that all the settings

you have entered will be cleared once you exit the

present setup screen.



If you would like to delete a timer program set

previously, go to Timer Record menu, highlight

the bin icon located in the ﬁrst column of the

entry you want to delete, then press ENTER.

Notice for Timer Recording

1. To stop a timer-recording session:

Press STOP to cease the timer recording. Please

note that it may take a few seconds before the

program is completely brought to an end.

2. To check the recording status while ‘Timer

Record’ is active:

Press DISPLAY to bring up the Timer Record

information on screen.

3. About the overlap of timer programs

1. Each time after you complete and save the

settings of a timer program, the DVD recorder

will check if this program overlaps with other

ones you set previously.

2. If the current timer program does overlap with

one or more than one programs, a window

asking if you would like to keep current setting

will appear.

Timer_03_01

......

3. If you select ‘Yes’, the screen will go back to

Timer Record menu. Under this circumstance,

the later program takes priority, which means

the DVD recorder stops recording the earlier

program at the start time of the later program.

4. If you select ‘NO’, the screen will go to the

setting page. You need to change or discard the

setting of this program.