Lexmark W810 用户指南
105
Loadin
g pa
per
Avoiding paper jams
If you select appropriate media (paper, transparencies, labels, and card
stock) for your printer, you’ll be well on your way to trouble-free printing. If
you do experience a paper jam, see “Clearing paper jams” on page 41 for
instructions on clearing the jam.
stock) for your printer, you’ll be well on your way to trouble-free printing. If
you do experience a paper jam, see “Clearing paper jams” on page 41 for
instructions on clearing the jam.
Here are a few hints for avoiding paper jams:
•
Use only recommended media. Refer to the
Complete Printer
Reference
for more information about which media will provide
optimum results for your printing environment.
If you need detailed information before purchasing large quanti-
ties of customized media, refer to the
ties of customized media, refer to the
Card Stock & Label Guide
on the
Drivers, MarkVision and Utilities
CD that shipped with your
printer.
•
Do not load wrinkled, creased, or damp paper.
•
Flex and straighten paper before you load it.
•
Do not overload the paper trays. Make sure the paper stack does
not exceed the maximum height indicated by the labels in the
trays.
not exceed the maximum height indicated by the labels in the
trays.
•
Push all paper trays
firmly
into the printer after loading them.
•
Make sure the paper guides in the trays are properly positioned
for the size paper you have loaded.
for the size paper you have loaded.
•
Tuck the edge of the paper stack completely under the corner
bucklers in trays 2 and 3 (and in tray 4 if you’ve attached an
optional 500-sheet drawer).
bucklers in trays 2 and 3 (and in tray 4 if you’ve attached an
optional 500-sheet drawer).
•
Load only standard-size paper in the trays.
•
Do not load 100% cotton paper in tray 1.
•
If you need to load paper in a tray while a job is printing, press the
Stop
button and wait for the printer motors to idle before you
remove the tray from the printer. After you reinstall the loaded
tray, press
tray, press
Go
to continue printing.
•
If an optional finisher is attached to your printer, do not staple,
hole punch, or offset transparencies, labels, or card stock.
hole punch, or offset transparencies, labels, or card stock.
•