Lexmark W810 用户指南
203
Removing options
Removing the duplex option
The duplex option consists of two components: the
duplex unit
(which you
must remove first) and the
manual feed unit
.
Some steps in this section instruct you to attach covers and screws that
were removed during initial installation of the duplex option. If possible,
locate these covers and screws before continuing. If you purchased the
Optra W810dn model with the duplex hardware already installed, these
covers will not be available.
were removed during initial installation of the duplex option. If possible,
locate these covers and screws before continuing. If you purchased the
Optra W810dn model with the duplex hardware already installed, these
covers will not be available.
NOTE: This procedure requires a long Phillips screwdriver.
Detaching the duplex unit
1
Turn the printer off and unplug the power cord.
2
Remove the connector cover on the right rear corner of the
printer.
printer.