MartinLogan helos20 用户手册
2101 Delaware Street, Lawrence, Kansas 66046, USA tel 785.749.0133 fax 785.749.5320 www.martinlogan.com
M
a r t i n
L
o g a n
the loudspeaker technology company
©2008 MartinLogan. All rights reserved.
Rev. #060408
®
Inductor .
A device designed primarily to introduce induc-
tance into an electrical circuit. Sometimes called a choke
or coil.
or coil.
Linearity .
The extent to which any signal handling process
is accomplished without amplitude distortion.
Midrange .
The middle frequencies where the ear is the
most sensitive.
NAC .
The abbreviation for natural ambience compensation.
Passive crossover .
Uses no active components (transis-
tors, ICs, tubes) and needs no power supply (AC, DC,
battery) to operate. The crossover in a typical loudspeak-
er is of the passive variety. Passive crossovers consist of
capacitors, inductors and resistors.
battery) to operate. The crossover in a typical loudspeak-
er is of the passive variety. Passive crossovers consist of
capacitors, inductors and resistors.
Phase .
The amount by which one sine wave leads or lags
a second wave of the same frequency. The difference is
described by the term phase angle. Sine waves in phase
reinforce each other; those out of phase cancel.
described by the term phase angle. Sine waves in phase
reinforce each other; those out of phase cancel.
Pink noise .
A random noise used in measurements, as it
has the same amount of energy in each octave.
Polarity .
The condition of being positive or negative with
respect to some reference point or object.
RMS .
Abbreviation for root mean square. The effective
value of a given waveform is its RMS value. Acoustic power
is proportional to the square of the RMS sound pressure.
is proportional to the square of the RMS sound pressure.
Resistance .
That property of a conductor by which it
opposes the flow of electric current, resulting in the gener-
ation of heat in the conducting material, usually expressed
in ohms.
ation of heat in the conducting material, usually expressed
in ohms.
Resistor .
A device used in a circuit to provide resistance.
Resonance .
The effect produced when the natural vibra-
tion frequency of a body is greatly amplified by reinforcing
vibrations at the same or nearly the same frequency from
another body.
vibrations at the same or nearly the same frequency from
another body.
Sensitivity .
The volume of sound delivered for a given
electrical input.
Stator .
The fixed part forming the reference for the moving
diaphragm in a planar speaker.
THD .
The abbreviation for total harmonic distortion. (See
Distortion)
TIM .
The abbreviation for transient intermodulation distortion.
Transducer .
Any of various devices that transmit energy
from one system to another, sometimes one that converts
the energy in form. Loudspeaker transducers convert elec-
trical energy into mechanical motion.
the energy in form. Loudspeaker transducers convert elec-
trical energy into mechanical motion.
Transient .
Applies to that which lasts or stays but a short
time. A change from one steady-state condition to another.
Tweeter .
A small drive unit designed to reproduce only
high frequencies.
Wavelength .
The distance measured in the direction of
progression of a wave, from any given point characterized
by the same phase.
by the same phase.
White noise .
A random noise used in measurements, as it
has the same amount of energy at each frequency.
Woofer .
A drive unit operating in the bass frequencies only.
Drive units in two-way systems are not true woofers but
are more accurately described as being mid/bass drivers.
are more accurately described as being mid/bass drivers.