MartinLogan dynamo 用户指南
WARNING! The power cord should not be
installed, removed, or left detached from the
subwoofer while the other end is connected to
an AC power source.
installed, removed, or left detached from the
subwoofer while the other end is connected to
an AC power source.
The IEC power cord should be firmly inserted into the
AC power receptacle on the rear connection panel of
the Dynamo, then to any convenient AC wall outlet. The
Dynamo also integrates a signal sensing power supply
that automatically switches off after sensing no music signal
for several minutes (this will occur when the power switch
is set to 'Auto').
AC power receptacle on the rear connection panel of
the Dynamo, then to any convenient AC wall outlet. The
Dynamo also integrates a signal sensing power supply
that automatically switches off after sensing no music signal
for several minutes (this will occur when the power switch
is set to 'Auto').
Your Dynamo subwoofer is wired for the power service sup-
plied in the country of original consumer sale. The AC power
rating applicable to a particular unit is specified both on the
packing carton and on the serial number plate attached to
the subwoofer.
plied in the country of original consumer sale. The AC power
rating applicable to a particular unit is specified both on the
packing carton and on the serial number plate attached to
the subwoofer.
If you remove your Dynamo subwoofer from the country of
original sale, be certain that AC power supplied in any sub-
sequent location is suitable before connecting and operating
the subwoofer. Substantially impaired performance or severe
damage may occur to the Dynamo subwoofer if operation is
attempted from an incorrect AC power source.
original sale, be certain that AC power supplied in any sub-
sequent location is suitable before connecting and operating
the subwoofer. Substantially impaired performance or severe
damage may occur to the Dynamo subwoofer if operation is
attempted from an incorrect AC power source.
If the fuse in your Dynamo should require changing, turn off
and unplug your Dynamo before removing the fuse. Replace
the bad fuse with a matching T 2A L 250V (T 1A L 250V if
you are in a region using 230v–240v current).
and unplug your Dynamo before removing the fuse. Replace
the bad fuse with a matching T 2A L 250V (T 1A L 250V if
you are in a region using 230v–240v current).
Break-In
Our custom made woofers require approximately 50 hours
of break-in at moderate listening levels before their optimal
performance occurs. This will factor in on any critical listening
and judgment.
of break-in at moderate listening levels before their optimal
performance occurs. This will factor in on any critical listening
and judgment.
12 Connections and Control Settings
AC Power Connection
Replacing the Fuse
Figure 13. IEC power cord AC receptacle and fuse.